Home » Technical Guides » How-To Guides

UltraWAP power over ethernet mods

Posted November 4th, 2006 by Anonymous

More power over ethernet mods. This one for an UltraWAP.


‹ Simple 3 Amp Step Down Switchmode RegulatorupSweeping the sky ›

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

Has been done before

Didz's picture
On November 4th, 2006 Didz says:

Ive seen these been done before on Minitar MNWAPB units which are very similar and is quite handy.

Personally I wouldnt use such thin wire to do that like shown on that picture. Wires from old PC power suplys are good for those sorts of things.


Power consumption is tiny..

On November 5th, 2006 adhoc (not verified) says:

Power consumption is tiny on these units, so the wire gauge probably isn't much of an issue?


idle a minitar is about

Seabird2k's picture
On November 5th, 2006 Seabird2k says:

idle a minitar is about 180mw
and transferring up to 250mw ****

that wire should be fine

**** no idea how accurate these figures are but they were posted on these forums a while back i think they were gathered experimentally by a member


http://www.air-stream.org.au/mnwapb

Didz's picture
On November 6th, 2006 Didz says:

FuNcHi did those tests in 2004, see http://www.air-stream.org.au/mnwapb.


ahh i see i was close

Seabird2k's picture
On November 6th, 2006 Seabird2k says:

ahh i see

i was close heh

what ever happend to FuNcHi?? away fighting for australia ?

or bogged in some creek in dingo w00p w00p :P


Hrmm don't know.

Didz's picture
On June 29th, 2007 Didz says:

Hrmm don't know.


Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.